If your 1st Gen B-hyve indoor/outdoor controller is not broadcasting the Orbit network it needs to connect to WiFi then these steps should help with that. Troubleshooting Steps Make sure the timer is in pairing mode. The controller will go out of pairing mode after an hour, so it is very possible you just need…Read More »
Tag Archives: Underground Timer
If your timer is running for only 1 second and then shutting off, it’s likely that your timer has the Rain Sensor terminals online. Your B-hyve controller will prevent the system from running if your Rain Sensor is active. You will still be able to run your controller in a manual cycle, but your custom…Read More »
There are two basic differences in the timer functionality: Gen2 uses Bluetooth for pairing to WiFi. Helps keep the entire experience in the B-hyve App for iOS, Android it’s a little less different. Gen1 uses AdHoc WiFi which takes a step or two more than the Bluetooth. Bluetooth allows the phone to stay connected to…Read More »
My station won’t turn on. How to troubleshoot a valve There are a few different possible causes of your stations not turning on. Your water may not be turned on. If you have a master valve, manually open that and then try running the timer again. If you have a pump, make sure that is…Read More »
If you have the B-hyve Indoor/outdoor timer (First GEN model) and you are trying to pair your device using an Android phone/tablet, then this article will help with getting your timer connected to your home WiFi. First-Time Setup Make sure the timer is plugged in and powered on. Verify that the Wi-Fi connection signal in…Read More »
If you have the B-hyve Indoor/outdoor timer (First GEN model) and you are trying to pair your device using an iOS phone/tablet, then this article will help with getting your timer connected to your home WiFi. First-Time Setup First-Time Setup Make sure the timer is plugged in and powered on. Verify that the Wi-Fi connection…Read More »
If your B-hyve indoor controller has gone offline, please use the following steps to help with getting it reconnected to your WiFi. Power Cycle controller A lot of the time, a simple power cycle of the controller will reconnect your controller. To do this, unplug your controller for 3-5 seconds, and then plug your controller…Read More »
Color and 8 segment LCD definitions: Button Panel Definition Flashing Blue P Pairing mode enabled Solid White Nothing Idle mode Waiting for program or command Flashing White Clockwise trailing Connecting to Wi-Fi or Server Green Station Solid Station is currently watering Yellow D Currently as a rain delay Flashing Red, white, and Blue Clockwise Trailing…Read More »